What's Actually Sitting on the Workbench
A fitting is only as trustworthy as the tools behind it. Here's what we run, and how we keep it honest against real outdoor rounds.
Launch Monitor for Flight, Bench Tools for Build Truth
A radar-based launch monitor tracks ball speed, launch angle, spin rate, and carry on every swing — the same data most fitting studios lean on. What sits next to it is what most studios skip: a frequency analyzer that clamps each shaft and reads its flex in cycles per minute, and a swingweight scale that balances head, shaft, and grip together.
Running all three means a bad number on one instrument gets caught by the other two instead of quietly making it onto your spec card.
Three Checks That Keep the Spec Card Real
Outdoor Validation Rounds
On a rolling schedule, fitters take finished builds to a Lincoln-area course and log real flight against the same clubs' bench readings, checking for drift.
Frequency Analyzer Calibration
The analyzer gets checked against a certified reference shaft monthly, since a drifting analyzer would quietly throw off every set matched against it.
Dual-Instrument Agreement
Launch numbers and bench numbers on the same club get compared before a recommendation goes on the spec card; a mismatch gets a manual re-check.
Why a Fixed Climate Actually Matters Here
Lincoln swings from single digits in January to humid, gusty afternoons in July — both of which change epoxy cure time, grip tackiness, and how a shaft's frequency reads on the analyzer. Holding the bench at a constant temperature removes that variable from every build, not just every swing.
It also means a February appointment and an August appointment produce numbers you can actually compare, instead of numbers that are secretly measuring the weather as much as your swing.
See Your Own Bench Reading
Every fitting appointment runs on the same three-instrument setup described above, cross-checked in real time.